Thanks, and yes we will be creating a clip that has no design but only has the conjuring creaitons art on the spine. The numbering on the clips were not done by the shop and that was a mes up on there part. I apoligize for that.
Are there plans to correct this before the clip is released, or will you ship them as they are, unnumbered?
As a last resort - and something interesting - you could write in fine-point Sharpie pen the serial number on the inside spine at one end, and give it your initials at the other for authenticity. The inside of the spine is the surface on the clip that will receive the least amount of wear and tear or contact friction with other objects. Unless someone opts to wash their clip, the ink should remain in place for the life of the clip.
Wouldn't the side of the deck rub against that though? Maybe I'm a little confused but I would imagine that the deck would rub against that and it would wear off.
@Don Boyer Yes, we have made plans to correct this issue. It was a mistake by our manufacturer, but we greatly apologize. We may have to fix the issue ourselves or have the manufacturer solve it, we haven't came to that conclusion as of yet.
@brown_baggs Yes, but not nearly as much as the wear on the outside. As far as we are concerned, that would be the best place to include it. Though, writing it down is surely going to be taken into consideration, however, there maybe other ways to go about this.
